We assemble all of our trophies. However, we are providing this information should you ever need to make changes or adjustments to your trophies/awards.
How to Attach Figures to Trophies
- Place figure / ER Riser on top of trophy
- Turn in a clockwise direction until figure/cup/riser is snug
- If figure / ER Riser is not in the desirable position, lay the trophy on its back and use a 7/16" wrench to slightly loosen the nut from the base of the trophy
- Advance the figure / ER Riser to the desirable position
- Once the figure / ER Riser is in the desirable position, tighten the bottom nut with the wrench.
How to Attach a Trim Eagle
- Lay the trophy on its back
- Place the eagle in the appropriate spot on the base
- Put the nut in the 7/16 wrench and tighten until eagle is affixed in the proper position.
How to Change Other Trophy Parts
- Lay the trophy on its back
- Use a 7/16” hand wrench to remove the necessary nuts from the base. Be sure you remove only the hardware that is in question.
- Place the new parts in the proper place.
- Reassemble the trophy and tighten the nut at the base until slightly snug.
- If necessary, reposition all parts so they are in the desired position.
- Tighten the nut at the base again until it is snug and none of the parts of the trophy are loose.